SKF 729101/300MPA Instrucciones De Uso página 12

Push the gauge adapter nipple into the top slot of the
adapter block.
Note:
to avoid misalignment the O-ring has to be located on
the flat part of the gauge nipple.
The following operation should be done carefully.
The illustration shows how the seal will be achieved.
Screw the high pressure pipe nipple into the back of the
adapter block, while gently moving the gauge adapter
nipple in order to secure the correct position of the high
pressure sealing area.
Make sure all parts are properly aligned. Failure in doing
so will prevent proper sealing and will cause leakage.
The component design helps achieve an effective sealing
with a moderate tightening torque.
10
E
D
A. Gauge nipple O-ring 226402-2
B. Oil injector 226400 E
C. Gauge adapter nipple 226402-1
D. Adapter block 226402
E. High pressure pipe
SKF 729101
A
B
C