8. Operating Procedure
8-1. User Setup
This dome camera is provided with user setup function for picture quality,
sync system selection and camera ID, P.Mask setting etc. The setup menu is
a tree type on-screen-display.
To make a camera setup procedure, connect the Setup Adapter as shown.
8-2. Names and functions of the setup adapter
E
U
R
L
D
* To get into Setup mode, hold E button more than 2 seconds.
L
The supplied setup adapter shown has four switches
and indications.
This setup adapter is used with setup unit connector
onto the camera unit.
(Refer to Drawing No.8-1)
Up switch (U)
Down switch (D)
Right switch (R)
Left switch (L)
Enter switch (E)
E-10
Setup Adapter
E
U
R
D
To select setup parameters
To change setup
parameters
To get in or get out to
setup mode, and to enter
and execute procedures.