Parts Supplied - Pioneer AVIC-F30BT Manual De Instalación

Installation
! The cords must not cover the area shown
in the figure below. This is necessary to
allow the amps and navigation mechanism
to dissipate heat.
Do not cover this area.
! The semiconductor laser will be damaged
if it overheats, so don't install the naviga-
tion unit anywhere hot — for instance, near
a heater outlet.

Parts supplied

Parts marked (*) are pre-installed.
The navigation unit
Side bracket*
(2 pcs.)
Flush surface screw
(5 mm × 9 mm)
(4 pcs.)
Screw for fixing the
side bracket*
(5 mm × 9 mm)
(4 pcs.)
Section
03
Holder*
Binding screw
(5 mm × 8 mm)
(8 pcs.)
Screw*
(3 mm × 6 mm)
(8 pcs.)
Trim ring*
21
Engb