Memory: Reviewing Readings; Stopping A Measurement - Microlife BP3GQ1-3P Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5.5. Memory: reviewing readings

At the end of a measurement, this monitor automatically
stores each result with date and time. This unit stores 60
memories.
Viewing the stored values
With the unit off, press the "M" button. The display first
shows "A," then shows an average of all measurements
stored in the unit.
Pressing the "M" button again displays the previous value.
To view a particular stored memory, press and hold the
"M" button to scroll to that stored reading.
Memory full
When the memory has stored 60 results, a new, measured
value is stored by overwriting the oldest value.
Clear all values
If you are sure that you want to permanently remove all
stored values, hold down the "M" button (the instrument
must have been switched off beforehand) until "CL"
appears and then release the button. If you do not want to
clear the values, press the POWER button. To permanently
clear the memory, press the "M" button while "CL" is
flashing.
Individual values cannot be cleared.

5.6. Stopping a measurement

If it is necessary to interrupt a blood pressure measure-
ment for any reason (e.g., the patient feels unwell), the
POWER button can be pressed at any time. The device
then immediately lowers the cuff pressure automatically
and enters sleep mode.
18

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido