Sun Microsystems Netra t 1120 Manual De Seguridad página 19

Handling and Taking Care of your
CD-ROM Disks
Please observe the following precautions when handling CD-ROM disks:
DO NOT touch the data side of the disk (the side of the disk with no label).
DO NOT apply paper labels or write on any part of the disk, data side or label
side.
If dust or fingerprints get on to the disk, wipe with a dry cloth from the center of
the disk to the edge.
DO NOT place the disk in any place where it will be subjected to direct sunlight
or high temperature.
Caution – Do not use Benzene, Paint Thinner, Record Cleaner, Static Repellent or
any type of CD Lens cleaner. These chemicals can damage the surface of the CD-
!
ROM disk. In addition, these fluids will build up on the lens cleaning brush in your
CD-ROM reader, reducing effectiveness.
Note – In some circumstances, if your CD-ROM disk does not have a clean data
surface, your system may fail to boot.
Safety Precautions
The following general safety precautions must be observed during all phases of
operation, service and repair of this equipment. Failure to comply with these
precautions or with specific warnings elsewhere in this manual violates safety
standards of design, manufacture and intended use of the equipment. Sun
Microsystems assumes no liability for the customer's failure to comply with these
requirements.
The safety precautions listed below represent warnings of certain dangers of which
Sun Microsystems is aware. You, as the user of the product, should note these
warnings and all other safety precautions necessary for the safe operation of the
equipment in your operating environment.
16 Netra t 1120/1125 Netra t 1120/1125 Compliance and Safety • August 1998