Sun Microsystems Netra t 1120 Manual De Seguridad página 7

To determine if your system is FCC Class A or FCC Class B, you must check the
marking on each peripheral and on your workstation. Each piece of equipment
should have an FCC statement marked on the unit. The FCC statement should
identify the equipment as Class A or Class B. If there is no indication of the Class in
the FCC statement, consider it to be Class A unless there is a mark which states
"FCC ID:" followed by alphanumeric characters. If it has this FCC ID mark, it is
Class B. If any of the peripherals in your system is not marked with an FCC
statement, the equipment should not be used in a home because of the greater
likelihood of interference to radio and television reception. Contact the manufacturer
of the peripheral if you have any questions.
Modifications
If the end-user adds single in-line memory modules (SIMMs) or internal drives or
PCI cards to the system, the FCC Class of the machine could be affected. All DIMMs
and internal drives offered by Sun for use in a Sun™ product have been tested and
will not change the FCC Class labeled on the product if it is installed per the
instructions in the Sun Netra t 1120/1125 Installation and Basic Maintenance Guide.
If memory, drives, or PCI cards are purchased from sources other than Sun, the FCC
Class of the system may be adversely affected. Modifications not approved by Sun
may void the authority granted by the FCC to operate the equipment.
Shielded Cables
Connections between the system and other external equipment must be made using
shielded cables, earthed at both ends, in order to maintain compliance with FCC
radio frequency emission limits.
FCC Class A Notice
Note – Note – This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the Sun Netra t 1120/1125 Installation and Basic Maintenance Guide,
may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case
the user will be required to correct the interference at his own expense.
USA – Electromagnetic Compatibility Information 3