Maintenance And Service - Garland MONTANA 110 Manual De Instrucciones

English
The operator should never:
- Cut with the tip of the rod (risk of Kickback).
- Hold a section of wood while performing the cut of
that same section.
- Try to grab sections that will fall.
7.7.3.5. RELEASE OF A JAMMED CHAINSAW
If the saw gets stuck during the cutting process, the
operator must:
1. Switch off the chainsaw.
2. Hold the chainsaw in the place where it is stuck
with a rope that will hook to a separate line of the
branch where the stuck chainsaw, or to the same
branch but to the part of the inner branch to cut
(the part of the branch between the incision and
the main trunk).
3. Pull the saw out of the incision while the cut is
opened by pushing the branch.
4. If you are unable to release the chainsaw by pulling
it, make a cut 30 cm away from the cut in which
the chainsaw is trapped on the outside of the
branch (the part of the branch that will no longer
be in the tree when the cut is made) in order to
free some weight in the cut and that the cut opens.
Never perform this cut on the inside of the branch
since chainsaw could fall with the cut piece of
branch, thus endangering the operator, the
operator on the ground, the chainsaw and rest of
team.

8. MAINTENANCE AND SERVICE

It is necessary to always turn off the engine and
check that the cutting tool is stopped before cleaning,
transporting, or modifying the cutting tool. Before
performing any maintenance or repair on the machine
make sure that the engine has stopped and remove
the spark plug pipe.
WARNING! Do not modify the machine or cutters.
Improper use of these elements can cause serious
personal damage or death.
Keep the machine clean, especially the area of the
fuel tank and areas close to the air filter.
Do not ever attempt to perform adjustments on
the machine if it is running. Perform all machine
maintenance with it on a cleared, flat surface.
Use only suitable replacement for this machine in
order to obtain a proper performance of the machine.
This replacement can be found in the official
distributors of the machine. The use of other spare
parts can cause risks, damage to the user, people
around and the machine.
Do not adjust the carburetor. If necessary, take
your machine in for service. Carburetor adjustment
is complicated, and only the technical maintenance
service must do them.
Incorrectly setting the carburetor may cause
damage to the engine and will be cause for
cancellation of the warranty.
Removing the security devices, improper maintenance,
or replacing the rod or chain with non-original spare
parts can cause injury.
56/160