Little Wave - Rear Seat Height Adjustment - Ki Mobility TSUNAMI AL Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
M. Little Wave - Rear Seat Height Adjustment
Rear seat height can be adjusted by repositioning the Tubular Component System (TCS).
1. Remove your wheels by depressing the buttons on the
quick release axle.
2. Use a 3mm Allen wrench and 8mm open end wrench to
remove the two bolts (Fig. 16:A) holding the upper and
lower mounting brackets together.
3. Reposition the mounting brackets to the desired height
and replace the two M5 bolts.
4. Repeat on both sides of the wheelchair.
NOTE: Height adjustments are in ¼" increments.
NOTE: A front caster adjustment should be made to
correspond with any change in seat angle.
WARNING: Lowering the seat height at the rear of the seat 0.50" or 2 positions of 0.25"
increments will decrease the rearward stability by ½ degree. The more you move your rear wheels
forward, the more likely your chair will tip over backwards.
Always make adjustments in small increments and check the stability of your chair with a spotter
to prevent a tip over. We recommend that you use anti-tip tubes until you adapt to the change and
are sure you are not at risk to tip over.
DANGER: Failure to heed these warnings may cause serious injury or death.
Fig. 16
27
A