Adjusting Backrest Position - Ki Mobility Little Wave Clik XP Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
X. Adjusting Backrest Position
To move the location of your Clik backrest:
1. Loosen two 6mm screws on backrest clamp (Fig. 33:A). Repeat on other side.
2. Grasp backrest clamp on each side and slide to desired location. It is important that you move
both sides equally. As adjustment is being made you will feel a clicking in the system. Take
care to move assembly equal distance on each side. Each click is equivalent to ½".
3. Once assembly is in desired location and has clicked into place, tighten the two 6mm screws
on backrest clamp (Fig. 33:A). Repeat on other side.
NOTE: When backrest has been moved, adjustments to COG (Section H), cross tube (Section
JJ) and seat upholstery (Section FF) may be required. Always check rearward stability of the
wheelchair after adjusting and before use.
WARNING: Moving the backrest rearward can decrease rearward stability of the chair. Always
make adjustments in small increments and check the stability of your chair with a spotter to
prevent a tip-over. We recommend that you use anti-tip tubes.
A
39
Fig. 33