Ikegami ICD-879 Manual De Instrucciones página 10

• For the DC controlled type auto iris lens
Set the lens selector switch to DC position.
– Connector cable wires –
1. Damping coil (-)
2. Damping coil (+)
3. Driving coil (+)
4. Driving coil (-)
* Connect the wires as shown above.
Please refer also to the instructions of the lens to be used.
⑦ - ⑪ Camera setup function switches
Please refer to the Operation chapter.
⑫ Focus EZ function switch
With an auto iris lens being connected, this switch is used to support the focus
adjustment. Hold down the U button longer than 2 seconds, and the lens aperture
is kept open for about 1 minute. (Press it again, and the aperture opening time
will be prolonged for about 30 seconds.)
To end the Focus EZ function, just press the D button. This function helps
adjust the focus easily even in broad daylight no matter how much the depth of
field is. After using this button, the unit resets itself to its original focus mode.
⑬ External input connector (GENLOCK IN)
For Gen-lock input signal.
⑭ Video Output connector (VIDEO OUT)
For video signal output from camera. Connect this output to monitor or switcher,
etc. This to be terminated with 75 ohms impedance at the last equipment in a
loop when cascade/bridge loop connection is made.
2
1
3
1
2
Connector pin assignment
E-7
4
3
4
Auto iris lens