Ikegami ICD-879 Manual De Instrucciones página 18

② VARIABLE
Speed of shutter can be changed
variably by L or R button, and the
shutter speed can be displayed on a
monitor screen. (When the setting
was so made)
(3) When Sensitivity Up is ON (SENS UP = ON)
The electronic sensitivity multiplying
factor can be adjusted with the L and R
buttons. x1, x2, x4, x6, x8, x12, x16, x24, x32
5-4-4 LIGHT CONTROL
(1) Select LIGHT CONTROL on the main menu using L or R button for AES or
LENS set. The Iris level can be displayed only when a lens change over switch
was on DC mode.
(2) BACKLIGHT CMP.
W i t h t h i s m o d e , t h e b a c k l i g h t
compensation modes can be controlled
by L or R button. (for ON, SPOT, or OFF).
① OFF
The backlight compensation is not
active. This is the factory setting.
② SPOT
In this mode, the Spot measurement can
be made by setting the desired point.
③ ON
This mode is an ordinary back light compensation.
(3) BLC LEVEL
Move the marker by L or R button. Factory setting is at the middle.
The good result can be seen by moving marker to the right side, when the
difference of light amount was larger. It is recommended to control this by
watching the monitor screen.
(4) WIDE BLC
If the picture turned to white and make it difficult to observe, try this to have
better picture. This WIDE BLC makes compensation range larger to have
moderate brightness level make a picture comfortable to eyes.
(5) IRIS LEVEL
This is displayed when using DC Iris lens. Lens Iris moves to open by sliding
the marker to right. (Open means to make it brighter )
For this adjustment, it is recommended to do by watching a monitor screen.
ＶＡＲＩＡＢＬＥ ＳＨＵＴＴＥＲ
ＳＰＥＥＤ Ｌ・・・・Ｉ・・・Ｈ
１／６０
ＲＥＴ ＥＸＩＴ
ＬＩＧＨＴ ＣＯＮＴＲＯＬ
ＢＡＣＫＬＩＧＨＴ ＣＭＰ． ＯＦＦ
ＢＬＣ ＬＥＶＥＬ Ｌ・・・・Ｉ・・・Ｈ
ＷＩＤＥ ＢＬＣ ＯＦＦ
ＩＲＩＳ ＬＥＶＥＬ Ｌ・・・・Ｉ・・・Ｈ
ＲＥＴ ＥＸＩＴ ＳＰＯＴ ＳＥＴ
E-15