Ikegami ICD-879 Manual De Instrucciones página 15

(2) ID characters setting
Keep CAMERA ID highlighted and press
the E button. The screen appears as
shown on the right figure.
① ID Setting for Line and Starting point:
For positioning the cursor, choose
arrow mark, ← or → , and push R or
L button.
② Choose desired characters, or
numbers, Use buttons of U, D, L, or
R to do it.
③ To use E button, to display the selected characters or numbers for ID.
④ To have a space, Select SPACE and push E button. the cursor moves.
⑤ To delete all ID characters and numbers, select CLEAR and push E button.
(3) Positioning of ID Display
ID display appears when push E button after choose POS. Move ID display to
the desired place and push E button. The ID position is set and the screen goes
back to normal screen.
(4) After this, decide to go back to the main menu (RET), or to save data and finish
this procedure (EXIT).
5-4-2. SENS UP
(1) This is to select the Electronic Sensitivity Increase function with L or R button.
The Gain mode will be AGC, while choosing Off, S/N or MOVE mode. It is
possible to change to HYP-AGC.
① OFF
Electronic Sensitivity Up function invalid.
② S/N
Signal to Noise priority Mode. It is recommended to shoot less or slow moving
object under lighting condition is varying.
③ STD (Factory Setting)
This is the Standard mode and this mode is recommendable under varying
lighting condition, but to have moderate TV reproduction in object blurr and
sreen noises as surface noises.
④ MOVE
This is the mode to have fast moving objects. The priority is on speed.
This may be used for the object such as cars on a street or in aparking lot
where objects are fast moving under varying light condition.
ＩＤ ＥＤＩＴ
ＡＢＣＤＥＦＧＨＩＪＫＬＭＮＯＰＱ
ＲＳＴＵＶＷＸＹＺ
０１２３４５６７８９
・・・・・・・・・・・・・・・・
← →
ＳＰＡＣＥ ＣＬＥＡＲ
ＲＥＴ ＥＸＩＴ ＰＯＳ
E-12
↑ → ↓ ←
：＋−＊／．・