Required Tools; Command Module; Actuator - Waeco MagicSpeed MS-400 Instrucciones De Montaje

MS-400.qxd 24/06/03
The tools required for the correct assembly of the cruise control are listed below: Alt-
hough this equipment can be mounted without some of the listed tools, we recommend
having these tools handy. It is highly recommended that you solder the connections to
ensure a stable connection.
- drill (see B 1)
- voltmeter (see
- soldering iron and material (see B 3)
- wire-cutting pliers (see
- insulation stripping tongs (see
- crimping pliers (see
- pliers (see B 7)
- drill set (see
- prick punch (see
- hammer (see
Module, (see C)
The actuator should be mounted in the engine compartment at the splash plate or on the
inner mudguards (see
the vicinity of a heat source and at a distance of at least 300 m from any high-voltage
source such as an ignition distributor, ignition coil, ignition cable or generator. The throttle
lever of the actuator should be led in a bow of at least 300 mm to the original accelerator
cable or throttle control lever.
Caution! Keep the throttle lever away from rotating or hot surfaces or parts.
It is possible to fasten the mounting plate of the actuator at 4 different positions at the
actuator, whereby a maximum flexibility will be ensured with the assembly (see
15:10 Page 45

Required tools

B 2)
B 4)
B 5)
B 6)
B 8)
B 9)
B 10)

Command module

Actuator

D 1). It is important to ensure that the actuator is not mounted in
- car jack (see B 11)
- set of screwdrivers (see
- set of socket wrenches (see
- axle assembly bay (see
- insulating tape (see
- ruler (see B 16)
- screw wrench (see
- set of ring spanner wrenches (see
- sealing compound (see B 19)
45
B 12)
B 13)
B 14)
B 15)
B 17)
B 18)
D 2).