Waeco MagicSpeed MS-400 Instrucciones De Montaje página 60

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 69
MS-400.qxd
24/06/03
15:10
Page 60
Adjustment/training mode
Drive the vehicle at a moderate speed to adjust the GAIN value. Press the SET button to
activate cruise control. Press the SET button again to increase the GAIN value or press
the RES button to decrease the GAIN value. You will hear an acoustic signal as a
confirmation of each keystroke.
Below you will find a practical procedure for adjusting the GAIN value optimally after you
have set cruise control into the setting mode (see above).
When driving your vehicle at a moderate speed, press the SET button to activate cruise
control. Switch off normal operation by activating the brake. Let the vehicle's speed
decrease by approx. 25-30 km/h. Press the RES key to recall the last saved speed. Now
look at the vehicle's speedometer. If the speed increases beyond the last saved speed,
then the GAIN value must be decreased by pressing the SET button again. If the cruise
control has taken up the speed too slowly, press the SET button to increase the GAIN
value.
Depress the brake to save the adjusted value. Press the RES button to check the setting.
If the setting is not satisfactory, you can modify the GAIN value as described above.
Depress the brake after successful setting to save the value. Point 6 must be observed
when leaving SETUP mode.
6. Leaving the SETUP mode
Stop your vehicle to leave the SETUP program and press the RES button 4 times while
the brake is activated.
You will hear a long, high acoustic signal as a confirmation that the SETUP program is
finished.
60

Publicidad

Tabla de contenido
loading

Tabla de contenido