Agilent Technologies Turbo-V 700HT Manual De Instrucciones página 286

17 Technical Information
Use
Figure 37
The run up time is factory-set to:
00h 10m 00s.
D
where: XXX = YES or NO.
This function is factory-set to YES.
286/304
Press the PUMP CURRENT push-button to enter the data.
When the last digit is entered, the display shows:
E L A Y
T H R E
Press the CYCLE NUMBER push-button and select YES if relay K2
must operate only after the run-up time or select NO when the K2
operation is needed right from start of the turbopump and after
the rotational speed of the turbopump exceeds for the first time
the speed threshold value (see the preceding cycle diagram).
Turbo-V 700HT Controller User Manual / 87-900-877-01 (F)
E V E N
S H O L D
A F T E
: X X
R
X