Sony VPL-HS3 Manual De Instrucciones página 37

6 While pushing the projector cover toward
you by holding both sides of the cover on
the lens side, close the cover until it clicks.
2
7 Connect the power cord and set the
projector to standby mode.
8 Press the following buttons on the remote
control in the following order for less than
five seconds each: RESET, <, ,, ENTER.
Notes
• Do not put your hands into the lamp replacement spot, and do
not allow any liquid or object to fall into it to avoid electrical
shock or fire.
• Be sure to use the LMP-H150 Projector Lamp for replacement.
If you use lamps other than LMP-H150, a malfunction may
occur.
• Be sure to turn off the projector and unplug the power cord
before replacing the lamp.
Disposal the used lamp
The used lamp contains Mercury, dispose according
to local, state or federal laws.
As the materials used in this lamp are similar to those
of a fluorescent lamp, you should dispose of a used
projector lamp in the same way as a fluorescent lamp.
1
37
Replacing the Lamp
GB