Sony FWD-S42H1 Manual De Instrucciones página 57

Parts Description
1 Main power switch Turn the main power switch to "ON"(press the side) when setting up the device.
When the main power switch is turned "OFF" (press the
is 0W.
2 AC IN socket Connect the supplied AC power cord to this socket and to a wall outlet. See page 19.
Once you connect the AC power cord and turn on main power switch, the
lights up in red and the display goes into the standby mode.
3 SPEAKER socket Connect the speakers SS-SPG01 (not supplied) to this socket. For more details on
connecting the speakers, see the operating manual that came with the speakers. For details
on how to route the speaker cords, see page 20.
4 Speaker installation Attach the dedicated speakers SS-SPG01.
positions
Screw holes conforming to VESA standard. (Pitch: 400mm × 400mm, Screw: M6)
5 Stand installation holes
6 Applicable display stand Use these hooks to install the display stand SU-S01 (not supplied).
installation holes
7 Dedicated display stand Remove when mounting the display stand SU-S01 (not supplied).
installation hole cover
8 1 (POWER) switch Switches the display on or off (standby).
Operate when the main power switch is "ON" ( side).
Press to select a signal to be input from the INPUT or OPTION connector.
9 INPUT/
The signal to be input switches as follows each time you press the INPUT button.
(ENTER)button
When an optional adaptor supporting the video signal is not installed in the OPTION slot,
OPTION will be skipped.
Press to set your choice.
0 +/–/F/f (volume/cursor) Press to control speaker volume. When the menu is displayed, press to move the cursor or
button set a value.
Press to set your choice.
Press to show menus.
qa MENU/ (RETURN)
button This returns to the preceding menu screen.
Serves to connect the display to a network, using a 10BASE-T/100BASE-TX LAN cable.
qs REMOTE
(10BASE-T/100BASE-TX) You can assign various settings and control the display via the network from a PC.
• When you connect the LAN cable of the unit to peripheral device, use the supplied cable to
• For safety, do not connect the connector for peripheral device wiring that might have
When using this connector, select "Display" in "Network Port". (page 32)
This is the audio monitor output terminal for external devices. Outputs an audio of the
qd AUDIO
(Stereo mini jack) signal currently indicated on the screen. Outputs an audio signal corresponding to the
active* picture while in the "P&P" or "PinP" mode.
• Settings assigned in "Sound Mode" or "Speaker Out" will not be reflected.
• The noise reduction status set by the remote control is not reflected.
S Video Video HD15
Cautions
prevent malfunction due to radiation noise.
excessive voltage to this port. Follow the instructions for this port.
Note
Note
side), the power consumption
DVI OPTION
FWD-S42H1/FWD-S47H1
indicator
1
GB
11
GB
4-111-559-01(2)