Sony FWD-S42H1 Manual De Instrucciones página 86

010COV.book Page 40 Friday, June 27, 2008 7:25 AM
Problem
No sound/Noisy sound.
Picture displayed, no sound.
Remote control does not operate.
Cannot connect to the network.
The display control screen (the
Web screen displaying the
display's GUI) does not appear.
40
GB
Possible Remedies
• Check the volume control.
• Press on the remote control or
from the screen (page 14).
• Check "Speaker Out" settings (page 30).
• Check the polarity of the batteries or replace the batteries.
• Point the remote control at the remote control sensor of the display.
• Keep the remote control sensor area clear from obstacles.
• Check "Control Setting" (page 30).
• Check whether a cable is connected to the CONTROL S IN
connector (BKM-FW21 not supplied). The remote control cannot be
used while the display is controlled via a CONTROL S connection.
• Fluorescent lamps can interfere with remote control operation; try
turning off the fluorescent lamps.
• Plug the cable firmly into the REMOTE connector.
• Check the network settings of the PC.
• Reset to the default settings by assigning the "All Reset" setting on
the "Setup" setting menu, and then assign the appropriate settings of
the network again.
• Check the settings in "Network Port." (page 32)
• Click the refresh or reload button on your Web browser.
• Make sure the IP address is correct.
• Use Internet Explorer 6.0 or later.
• Clear the browser cache.
+ so that Muting disappears
FWD-S42H1/FWD-S47H1
4-111-559-01(1)