Replacing The Filters - Titan RENTSPRAY 600 Manual Del Propietário

NOTE: coat the piston guide tool and the piston rod
with grease before inserting them into the pump
block.
13. Using a wrench, tighten the retainer nut securely.
14. Slide the top of the piston rod into the T-slot on the slider
assembly.
15. Position the pump block underneath the pump housing
and push up until it rests against the pump housing.
16. Thread the pump block mounting screws through the
pump block and into the pump housing. Tighten securely.
17. Reassemble the foot valve assembly into the pump block.
18. For High Rider cart units, thread the siphon tube into
the foot valve and tighten securely. Make sure to wrap
the threads on the siphon tube with Teflon tape before
assembly. Replace the return hose into the hose clip on
the siphon tube.
19. For Skid and Low Rider units, insert the elbow on the
siphon assembly into the bottom of the foot valve housing.
Push the retaining clip up into the groove inside the foot
valve housing to secure the siphon assembly in position.
Thread the return hose into the pump block and tighten
securely.
20. Place the front cover on the pump housing and secure in
position using the four front cover screws.
21. Turn on the sprayer by following the procedure in the
"Operation" section of this manual and check for leaks.
NOTE: Repacking kit P/N 704-586 is available. For best
results use all parts supplied in this kit.

Replacing the Filters

Pump Filter
1. Loosen and remove the filter housing by hand.
2. Slip the filter off of the filter support spring.
3. Inspect the filter. Based on inspection, clean or replace
the filter.
4. Inspect the seal. Based on inspection, clean or replace
the seal.
5. Slide the new or cleaned filter over the filter support spring
with the adapter in place. Push the filter into the center of
the pump block.
6. Slide the filter housing over the filter and thread it into the
pump block until secure.
NOTE: The filter housing should be hand-tightened, but
make sure the filter housing is seated fully into
the pump block.
Filter support
spring
Seal
Pump
block
English
Filter
Adapter
Filter
spring
Filter housing
Gun Filter
1. Pull down on the bottom of the trigger guard and swing it
away from the handle.
2. Slide off the handle and unscrew the handle tube from the
gun head.
3. Turning clockwise, unscrew the filter from the gun body.
NOTE: Left-handed threads require turning the filter
clockwise to remove.
4. Screw the new or cleaned filter counterclockwise into the
gun head.
5. Slide the handle tube over the filter and screw it into the
gun head.
6. Slide the handle over the handle tube and reattach it to the
gun head.
7. Secure the trigger guard back in position on the bottom of
the handle.
NOTE: For more detail, part number information, and
complete assembly drawings, please see the
LX-80 Platinum Gun Owner's Manual (P/N 313-
2302).
12 © Titan Tool Inc. All rights reserved.