Engine Running Behavior; Storing The Machine; Sharpening Metal Cutting Blades - Stihl FS 56 Serie Manual De Instrucciones

English

Engine Running Behavior

If engine running behavior is
unsatisfactory even though the air filter
is clean and the carburetor is properly
adjusted, the cause may be the muffler.
Have the muffler checked for
contamination (carbonization) by your
servicing dealer.
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer.
34

Storing the Machine

For periods of about 3 months or longer
Drain and clean the fuel tank in a
N
well ventilated area.
Dispose of fuel properly in
N
accordance with local
environmental requirements.
Run the engine until the carburetor
N
is dry – this helps prevent the
carburetor diaphragms sticking
together.
Remove, clean and inspect the
N
cutting attachment. Coat metal
cutting attachments with corrosion
inhibitor.
Thoroughly clean the machine – pay
N
special attention to the cylinder fins
and air filter.
Store the machine in a dry and
N
secure location – out of the reach of
children and other unauthorized
persons.
Sharpening Metal Cutting
Blades
Use a sharpening file (see "Special
N
Accessories") to sharpen dull
cutting attachments. In case of
more serious wear or nicks:
Resharpen with a grinder or have
the work done by a dealer – STIHL
recommends a STIHL servicing
dealer.
Sharpen frequently, take away as
N
little metal as possible – two or three
strokes of the file are usually
enough.
1 1
2
Resharpen the teeth (1) uniformly –
N
do not alter the contour of the parent
blade (2) in any way.
See cutting attachment packaging for
additional sharpening instructions. Keep
the packaging for future reference.
Balancing
After resharpening about 5 times,
N
check the cutting tool for out-of-
balance on a STIHL balancer
(special accessory) or have it
checked by a dealer and re-
balanced as necessary – STIHL
recommends a STIHL servicing
dealer.
FS 56, FS 56 R, FS 56 C, FS 56 RC
2