Balancing The Machine - Stihl FS 56 Serie Manual De Instrucciones

Full Harness
2
Put on the harness (1) and close the
N
locking plate (3).
Adjust the length of the strap – with
N
the machine attached, the
carabiner (2) must be about a
hand's width below your right hip.
Balance the machine – see
N

"Balancing the Machine".

FS 56, FS 56 R, FS 56 C, FS 56 RC
Balancing the Machine
The type and style of the harness and
carabiner (spring hook) depend on the
1
market.
The carrying ring is integrated in the
control handle on loop-handled units–
3
see "Main Parts". Loop-handled units do
not need to be balanced.
Attaching the unit to the harness
1
2
Attach the carabiner (1) to the
N
carrying ring (2) on the drive tube.
2
1
Loosen the screw (3).
N
Floating position
Mowing heads and grass cutting
N
blades should just touch the ground.
Proceed as follows to adjust the floating
position:
Move the carrying ring up or down
N
the drive tube – tighten the screw
moderately – let the unit go and wait
until is its balanced – then check the
floating position.
English
27