4-Mix Engine; Fuel - Stihl FC 100 Manual De Instrucciones

English / USA
7
6
4
9
8
: Position blade (7) on the thrust
plate (8).
Collar (see arrow) must engage
hole in blade.
: Fit thrust washer (4) on the shaft (9).
: Block the shaft.
: Screw the nut (6) on to the shaft
counterclockwise and tighten down
firmly.
If the cup spring (10) on the nut (6)
becomes fatigued, install a new nut.
18

4-MIX Engine

The STIHL 4-MIX engine features gas
oil lubrication and must be run on a fuel
mixture of gasoline and engine oil.
It operates otherwise on the 4-stroke
10
principle.
7

Fuel

This engine is certified to operate on
unleaded gasoline and the STIHL two-
stroke engine oil at a mix ratio of 50:1.
Your engine requires a mixture of high-
quality gasoline and quality two-stroke
air cooled engine oil.
Use mid-grade unleaded gasoline with a
minimum octane rating of 89 (R+M/2). If
the octane rating of the mid-grade
gasoline in your area is lower, use
premium unleaded fuel.
Fuel with a lower octane rating may
increase engine temperatures. This, in
turn, increases the risk of piston seizure
and damage to the engine.
The chemical composition of the fuel is
also important. Some fuel additives not
only detrimentally affect elastomers
(carburetor diaphragms, oil seals, fuel
lines, etc.), but magnesium castings and
catalytic converters as well. This could
cause running problems or even
damage the engine. For this reason
STIHL recommends that you use only
nationally recognized high-quality
unleaded gasoline!
FC 100