Lutron GRAFIK Eye QS Serie Manual De Montaje Y Utilización página 21

Adjusting Window Treatment Settings
Preset Adjustment: Simple Method
1. Use the raise and lower
buttons on the shade
column to set all EDUs
(electronic drive units of
the window treatments)
to the desired preset
levels.
2. Press and hold the
middle button on the
shade column for 5
seconds to save the
EDU preset positions.
The LED next to the
button will flash and
then light continuously,
indicating the preset
has been stored.
Note: Once EDU presets have been
assigned to buttons on a shade column,
those presets are accessible for an EDU
only using the shade column it is
assigned to, and a shade column can
access preset levels only for those EDUs
assigned to it.
R
Preset Adjustment: Advanced Method
Note: The advanced method for adjusting
presets is needed only if you wish to have
the window treatments assigned to the
shade column set at different positions in
the preset. If, however, you wish all the
window treatments in the group to be
lined up with one another in the preset,
you should use the Simple Method at left.
Note: Entering Assignment mode will
cause the window treatments to move
between their open and close limits. Be
sure that the open and close limits have
been set correctly.
1. On the shade column
whose preset you wish
to adjust, press and
hold simultaneously the
top and bottom
buttons. The LEDs next
to the buttons will flash.
EDUs (electronic drive
units) for the assigned
window treatments will
move to their closed
limits, and EDUs for
unassigned window
treatments will move to
their open limits.
2.Press and release the middle button on
that shade column. The adjacent LED will
blink rapidly. EDUs for assigned window
treatments will automatically move to
their current preset settings.
3. Use the raise and lower
buttons to move all EDUs
for assigned window
treatments together to the
desired preset setting.
4.To move an EDU individually to its
desired preset setting, select the EDU
using the top button on the shade
column. Each time you press and release
the top button, a different EDU that is
assigned to that shade column will open
and close in an 8-inch range. Press
repeatedly until the EDU for the window
treatment you wish to adjust moves.
Adjust that EDU to the desired height
using the raise and lower buttons.
Repeat this step for all assigned EDUs.
5.Once you are satisfied that all the
assigned EDUs are set to the positions
you want to assign as the preset, press
and hold the middle button on the shade
column for 5 seconds. The preset will be
saved.
6.Press and hold simultaneously the top
and bottom buttons on the shade column
for 5 seconds to exit to normal mode.
The LEDs next to the buttons will stop
flashing.
GRAFIK Eye QS System Installation and Operation Guide 21
®