Lutron GRAFIK Eye QS Serie Manual De Montaje Y Utilización página 9

Zone Setup
Set High End or Low End
High and low end trim settings limit the
Main menu
maximum and minimum output of a
dimming zone. Trim levels are set
Occ sensor
automatically when the load type is
Zone setup
programmed. Change the high or low
end trim for a zone only if the default
Zone setup
setting needs to be adjusted.
1. Enter programming mode (see page 12).
High end
2. Use the master buttons to highlight "Zone
Low end
setup" and press the OK button to
accept.
3. Use the master buttons to highlight "High
Low end
end" or "Low end" (this example shows
low end). Press the OK button to accept.
Set trim using
4. Use the zone raise/lower buttons to set
zone controls
the high end or low end trim for that
zone.
Zone 2
The info screen will display each zone
number and percentage as you adjust it.
Press the OK button to accept.
10%
5. The info screen will display a
confirmation screen that your setting has
been saved.
6. Exit programming mode (see page 12).
Saved
Saved
R
1
Set Minimum Level (optional)
Some local regulations specify a
Zone setup
minimum lighting level for dimming
zones in occupied buildings. If this
Low end
pertains to you, follow these steps to
Min level
set up your minimum lighting level.
1. Enter programming mode (see page 12)
Min level
and select "Zone setup," then "Min
level". Press the OK button to accept.
2. Use the master buttons to highlight
OFF
"OFF" if you want your lights to go all
the way off at their minimum light level,
or "10%" if you want that to be the
minimum light level. Press the OK button
to accept.
Saved
Saved
Note: Non-dim loads will turn off
regardless of the minimum level setting.
3. The info screen will display a
confirmation screen that your minimum
level has been saved.
4. Exit programming mode (see page 12).
GRAFIK Eye QS System Installation and Operation Guide 9
®
Master
buttons
OK
OK
button
Use the
zone
2 3 4 5 6
raise/lower
buttons to
set the high
end or low
end trim for
that zone.