Lutron GRAFIK Eye QS Serie Manual De Montaje Y Utilización página 22

Adjusting Window Treatment Settings
Name a Group of Window Treatments
Main menu
1. Enter programming mode (see page 12).
2. Use the master buttons to highlight "Shade labels" and press
Zone setup
the OK button to accept.
Shade labels
3. Use the master buttons to select your desired shade group.
Press the OK button to accept.
4. Use the master buttons to highlight "Custom" and press the OK button to accept.
Select shade grp:
5. Use the master buttons to scroll through the characters (lowercase and uppercase
letters, plus numbers 0-9). The character you are currently changing will be
Shade grp 1
underlined on the screen. Press OK to select the character you want, then repeat
for all available characters. Choose a space (no character) and press OK for any
remaining characters. Press the OK button to accept.
Label shade grp:
6. The info screen will display a confirmation screen that your name has been saved.
7. Exit programming mode (see page 12).
Custom
Label shade grp 1
1 / 11 Saved
A
1: A
Remotely Restore EDUs to Factory
Defaults
Warning! Restoring an EDU
(electronic drive unit for a window
treatment) to its factory defaults
will erase any previous
programming or assignments you
have made for that EDU.
Note: Entering this mode may
cause window treatments to
move approximately 8 inches up
or down. Be sure that each
window treatment is positioned
so that the fabric can safely
move 8 inches up or down
before entering this mode.
R
Saved
3.Select the EDU you want to restore to
factory defaults using the top button on
the shade column. Each time you press
and release the top button, a different
EDU in your system will open and close
in an 8-inch range to indicate it is
selected. Press the top button until the
1. On any shade column,
press and hold
simultaneously the top
and lower buttons.
The LED next to the
top button will flash.
2. Press and hold the top
button for 5 seconds.
All shade column
LEDs will blink rapidly.
GRAFIK Eye QS System Installation and Operation Guide 22
®
OK
EDU for the window treatment you wish
to restore to factory defaults moves. (You
can also use the bottom button, which
moves through the assigned EDUs in the
opposite order.)
4.Press and hold simultaneously the raise
and lower buttons for 5
seconds to restore the moving
shade to factory defaults.
5.Repeat steps 3 and 4 to restore factory
defaults to any other window treatments.
6.Press and hold simultaneously the top
and lower buttons on the shade column
to exit this mode.
Master
buttons
OK
button