Bosch HDC100 Instrucciones De Funcionamiento Y Seguridad página 8

2610048761.qxp_HDC100, 200, 250, 300, 400 10/25/17 1:47 PM Page 8
HDC100
Set the depth gauge by compressing the
telescopic guide toward the tool. When the
desired length of the bit is exposed, press and
slide the depth stop button against the guide
housing and release the button (Fig. A11). The
depth gauge is spring loaded and will return to
the fully extended position when pressure has
been released. (When drilling, the telescopic
guide will compress until it engages the depth
stop button.)
FIG. A12
CHIPPING APPLICATION
The HDC100 can be used with your SDS-
plus® rotary hammer for chipping applications
in concrete/masonry (see 'Hammer Dust
Extraction Attachments Compatibility' chart for
specific models).
Note: only use with pointed or narrow flat
chisels.
- Remove the gray dust seal from the
HDC100 attachment (see Fig. A1).
- Insert the chisel into the tool – follow the
same steps as for inserting a drilling bit).
- Adjust the telescoping guide so that the
chisel extends beyond the dust cap by 2"-4"
(Fig. A13). Open the housing clamp lever
and slide the housing forwards or backwards
for the desired position. Secure the housing
by closing the housing clamp lever.
Note: the dust collection attachment used in a
chipping application is designed to capture the
airborne dust and not the larger bits and pieces
of concrete that fall off in the removal process.
Operating Instructions
HOUSING
CLAMP
LEVER
-8-
ADJUSTING THE TELESCOPIC GUIDE
TO THE BIT LENGTH
The length of the telescopic guide can be
adjusted to desired bit lengths (maximum bit
length is 10", 8" useable).
To adjust length, open the housing clamp
lever and slide the housing forwards or
backwards for the desired positioning of the
attachment. Secure the housing by closing
the housing clamp lever. Note: the tip of the
bit should match the side of the dust cap that
touches the work surface (Fig. A12).
FIG. A13
HOUSING
CLAMP
LEVER