Bremont BOEING 1 Manual Del Usuario página 5

BREMONT BOEING MODEL 1
AUTOMATIC CHRONOMETER
Your Bremont watch shows you the time in hours, minutes and seconds, and the date.
The mechanical movement with automatic winding has a free-swinging rotor that
keeps the mainspring wound via the motion of your wrist. The movement in your
Model 1 has 25 jewels, runs at 28,800 bph and has a 38-hour power reserve once fully
wound. The watch is water resistant to 100m (10ATM) and the dial is protected by a
dual anti-reflective sapphire crystal that is retained securely in the case.
To ensure that this rather special watch continues to run beautifully for years to
come you must follow a few important operating instructions...
WINDING THE WaTCH
Your watch has a screw-in crown. The purpose of the screw-in crown is to protect the
watch from penetrating water and to avoid unintentional adjustment of the time or
date. To unscrew the crown, rotate the crown to the left where it will automatically
assume position I. Your Model 1 can be wound from crown position I by rotating the
crown in a clockwise motion. The movement will automatically start with just a few
revolutions of the rotor, however it is better to wind the movement fully with 30-40
revolutions of the crown. By doing this you will achieve maximum accuracy and have a
power reserve of 38-hours, even when the watch is not on your wrist.
SETTING THE DaTE
You can adjust the date by pulling out the crown to position II. You will now be able
to change the date by rotating the crown clockwise.
Do not change the date between 20:00 and 03:00
SETTING THE TIME
Pull the crown out to position III, this will stop the movement, you can now position
the minute hand exactly. To start the second hand, push the crown back to position
I. When setting the time, it is worth noting that the date change always takes place
at mid-night (00:00). If this change has already taken place at 12:00 noon, you must
move the hands forward by 12 hours. Ensure that the crown is screwed back in after
setting the watch. This can be achieved by gently pressing the crown down whilst
rotating it in a clockwise direction.
USING THE ROTaTING BEzEL
Your Model 1 has a bi-directional rotating bezel which can be used to keep track of
elapsed time. For example, if the time on your watch reads 12:15, align the triangle on
the bezel with the minute hand. Now, say the time is 12:30, the minute hand position
will point towards 15 on the bezel, indicating that 15 minutes of time has elapsed.
CHRONOMETER TESTING
Your Bremont watch is chronometer tested and accompanied by a performance
certificate issued by the 'Controle Officiel Suisse des Chronometeres' (COSC) to
show that the mechanical movement has passed all of the rigorous precision tests -
a necessity of the chronometer designation.
Remember to complete and return the COSC registration card to Bremont to
register your watch and receive your certificate.