Bremont SUPERMARINE S300 Manual Del Usuario página 4

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
ChANgINg ThE STRAP
RemovIng a stRap
Use the end of your watch tool to
carefully lever the spring bar out
of the lug.
FIttIng a stRap
Place one end of the spring bar
into the hole in the lug and use the
end of the watch tool to lever the
other end into position.
SUPERMARINE S300/301
AUTOMATIC CHRONOMETER
Your Bremont watch shows you the time in hours, minutes and seconds,
and the date. The mechanical movement with automatic winding has a
free-swinging rotor that keeps the mainspring wound via the motion of
your wrist. The movement in your Supermarine S300/301 has 21 jewels,
runs at 28,800 A/h and has a 38-hour power reserve once fully wound.
The S300/S301 is water resistant to 300m (30ATM). The dial is protected
by an anti-reflective sapphire crystal that is retained securely in the case.
To ensure that this rather special watch continues to run beautifully for
years to come you must follow a few important operating instructions...
wINdINg ThE wATCh
Your watch has a screw-in crown. The purpose of the screw-in crown is
to protect the watch from penetrating water and to avoid unintentional
adjustment of the time or date. To unscrew the crown, rotate the crown in
an anti-clockwise direction where it will automatically assume position
I. This position is also the winding position for the watch, where you can
manually wind the watch by hand. The movement will automatically start
with just a few revolutions of the rotor, however it is better to wind the
movement fully with 30-40 revolutions of the crown. By doing this you

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Supermarine s301

Tabla de contenido