Program Edit - Sony DAR-X1R Manual De Instrucciones

Program Edit

+
HDD RW - RW
VR
- R
Video
You can select scenes from a DV/Digital8 format
tape, and then automatically record selected
scenes to the HDD or a DVD.
To use this function, do the following:
Connect your digital video camera and prepare
for recording
m
Select and edit the scenes you want to dub
Using the recorder's remote control, fast forward
or rewind the tape to select the scenes. At this
point, the selected scenes are not copied to the
disc. The recorder only remembers the IN and
OUT points of the scenes that you selected for
dubbing. You can also erase or change the order of
the scenes.
m
Dub the selected scenes
After you have selected the scenes, the recorder
will fast forward and rewind the tape
automatically and record the scenes to the HDD or
a DVD.
How chapters are created
The contents dubbed to the HDD or DVD become
a single title. When "Auto Chapter" is set to "On"
in the "Recording" setup, this title is divided into
chapters. When dubbing to the HDD or a DVD-
RW/DVD-R (VR mode), each shooting session on
the tape and each selected scene becomes a
chapter on the disc. For other discs, the recorder
divides the title into chapters at approximately
6 minute intervals.
1
Follow steps 1 to 6 of "Preparing for DV
dubbing" on page 104, and press SYSTEM
MENU.
+
- RW R
- R
VR
Video
2
Select "DV EDIT," and press
The display asks if you want to start selecting
scenes.
• If you have previously saved a programme,
the display asks if you want to edit an
existing programme or to create a new
programme. To resume editing the existing
programme, select "Saved Data," and go to
step 9.
3
Select "Start," and press
The display for setting the IN point (start of
the scene) appears.
The scene starts to play.
4
Select the IN point using m/M, and
press .
Playback pauses.
5
Press if the IN point is correct.
If the IN point is incorrect, select the IN point
using c/C, and press
The display for setting the OUT point (end of
the scene) appears.
6
Select the OUT point using m/M, and
press .
Playback pauses.
7
Press if the OUT point is correct.
If the OUT point is incorrect, select the OUT
point using c/C, and press
The selected scene is added to the scene
information block.
• To add more scenes, go to step 4.
.
.
.
.
GB
,continued 107