Operating Controls; Start-Up - Cub Cadet 17BIDGHB603 Instrucciones De Funcionamiento Originales

EN
Charging the battery
WARNING !
Electrolyte liquid even discharges from
sealed batteries.
Avoid tilting the battery.
battery with a 12 Volt battery charger (maximum
charging current 6 amps) for one to two hours.
charger plug.
Then disconnect the battery (see also operating
instructions for the battery charger).
Attention !
Follow the instructions in the operating manual
for your battery charger.

Operating controls

Overview
1 Forward pedal
2 Reverse pedal
3 Clamping lever for steering column
4 Cutting height adjustment lever
5 Throttle / choke*
6 Choke*
7 Display cluster*
8 PTO switch
9 Ignition lock*
10 Fuel tap
11 Fuel tank
12 Tank level indicator*
13 Gear release lever
14 Trailer coupling*
15 Can holder
16 Seat adjustment lever*
17 Steering wheel
18 Switch for parking brake / speed control
19 Brake pedal
(* model-dependent)

Start-up

Check:
all protective features
the engine-oil level (see the engine handbook)
the fuel level
tyre pressure
the side coverings, accessory equipment, the
16
Fill up with fuel and check the oil level
Note
the factory – please check the oil, if required
Use unleaded petrol.
Fill fuel tank up to max. 2 cm below the lower
edge of the inlet nozzle.
Seal the fuel tank tightly.
Check the oil level. The oil level must be between
the "Full/Max." and "Add/Min." mark (see also
engine manual).
Check tyre pressure
Check the tyre pressure on all wheels and correct
it where necessary (for max. tyre pressure, see
tyre wall).
Setting the driver's seat
model and design)
Note
Depending on the design, the device may
have an adjustable seat with a built-in pres-
ence sensor.
Sit on the driver's seat.
Press the adjustment lever to the left and keep it
held .
Bring the seat to the desired position
the adjusting lever .
Note
When releasing the adjustment lever, make
sure the seat latches in correctly.
Move the armrests upwards
Turn the adjusting segment into the required posi-
tion :
- 0 = Lowest position
- 3 = Highest position
Move the armrests downwards.
Fitting the steering column
Upper part [B] of the steering column
Release the clamping lever in an anti-clockwise
direction .
Tip the steering column forwards into the required
position .
Tighten the clamping lever in a clockwise direc-
tion to lock the steering column in this position.
Operating controls
(depending on
and leave
.
769-10224B