Operating Controls; Start-Up - Cub Cadet 17AIEACI603 Instrucciones De Funcionamiento Originales

Operating controls

Attention!
Disconnect and connect the battery in the correct
sequence.
Only operate the battery with the battery terminal
protective battery cover).
Note
The battery is situated under the passenger
seat.
the factory.
Installation
First connect the red cable (+ / positive ter-
minal) .
Then connect the black cable
(- / negative terminal)
Fit the battery terminal cover
Removal
Remove the battery terminal cover.
First disconnect the black cable (- / negative
terminal).
Then disconnect the red cable (+ / positive ter-
minal).
Charging the battery
WARNING!
Electrolyte liquid even discharges from
sealed batteries.
Avoid tilting the battery.
battery with a 12 Volt battery charger (maximum
charging current 10 amps) for one to two hours.
charger plug.
Then disconnect the battery (see also operating
instructions for the battery charger).
Attention!
Follow the instructions in the operating manual
for your battery charger.
.
.
Operating controls
Overview
A Pedal for raising the cutting deck
B Clamping screw for drive control lever adjust-
ment
C Right drive control lever
D Throttle / choke *
E Ignition lock
F Choke *
G PTO switch
H Display cluster *
I Can holder / storage compartment
J Gear release lever
K Trailer coupling *
L Fuel tank
M Driver seat
N Height adjustment star knob for raising the cutter
deck
O Left drive control lever
P Headlamp *
(* model-dependent)

Start-up

Before operating the unit, always
Check:
• All safety equipment/protective devices
• The engine oil level (see the engine handbook)
• The fuel level
• Tyre pressure
• The side coverings, accessory equipment, the
Fill up with fuel and check the oil level
Note
Use unleaded petrol.
Fill fuel tank up to max. 2 cm below the lower
edge of the inlet nozzle.
Seal the fuel tank tightly.
Check the oil level. The oil level must be between
the "Full/Max." and "Add/Min." mark (see also
engine manual).
EN
15