Operating Controls; Start-Up - Cub Cadet 17AIEACI603 Instrucciones De Funcionamiento Originales

Operating controls

Attention!
¾ Disconnect and connect the battery in the correct
sequence.
¾ Only operate the battery with the battery terminal
cover fitted (depending on the model, as a
cover flap on the positive terminal or a complete
protective battery cover).
Note
The battery is situated under the passenger
seat.
The battery is filled with battery acid and sealed at
the factory.
Installation Bi
First connect the red cable(s) (+ / positive ter-
Î
minal) 1 .
Then connect the black cable(s) (- / negative
Î
terminal) 2 .
Attach the battery terminal cover.
Î
Note
Where devices have additional electrical
accessories, such as power steering, 12 V
socket, cutter deck height adjuster, etc., the
connection cables must be grouped together
(e.g. using cable ties) in cable groups (all
red or all black cables). If cable group exist,
always position the thickest cable in the
group next to the battery terminal.
Removal
Remove the battery terminal cover.
Î
First disconnect the black cable(s) (- / negative
Î
terminal).
Then disconnect the red cable(s) (+ / positive
Î
terminal).
Charging the battery
Electrolyte liquid even discharges from
sealed batteries.
ÂRisk of injury and fire
¾ Avoid tilting the battery.
Before using for the first time, charge the battery
Î
with a 12 Volt battery charger.
• Lead-acid battery:
Maximum charging current 4 amps for 1-2 hours
• AGM battery:
Maximum charging current 1.1 amps for 12-14
hours
After charging the battery, first pull out the battery
Î
charger plug.
Then disconnect the battery (see also operating
Î
instructions for the battery charger).
WARNING!
Attention!
¾ Follow the instructions in the operating manual
for your battery charger.
Operating controls
Overview A
A Pedal for raising the cutting deck
B Clamping screw for drive control lever adjust-
ment
C Right drive control lever
D Throttle / choke *
E Ignition lock
F Choke *
G PTO switch
H Display cluster *
I Can holder / storage compartment
J Gear release lever
K Trailer coupling *
L Fuel tank
M Driver seat
N Height adjustment star knob for raising the cutter
deck
O Left drive control lever
P Headlamp *
(* model-dependent)

Start-up

Before operating the unit, always
Check:
• All safety equipment/protective devices
• The engine oil level (see the engine handbook)
• The fuel level
• Tyre pressure
• The side coverings, accessory equipment, the
area around the air filter for dirt and grass
Fill up with fuel and check the oil level
Note
The engine has already been filled with oil in
the factory – please check the oil, if required
refill.
Use unleaded petrol.
Î
Fill fuel tank up to max. 2 cm below the lower
Î
edge of the inlet nozzle.
Seal the fuel tank tightly.
Î
Check the oil level. The oil level must be between
Î
the "Full/Max." and "Add/Min." mark (see also
engine manual).
EN
15