Sanding Motion; Choice And Installation Of Sanding Pads - Festool RO 125 FEQ Manual De Instrucciones

All manuals and user guides at all-guides.com
You can use the switch (6.1) to set two dif-
ferent sanding motions.
when the sanding pad is stationary, as the
switch is locked in place during operation
for safety reasons.
Rotex rotary motion (coarse sanding,
polishing)
Slide the switch (6.1) into the right posi-
tion.
Eccentric motion (fi ne sanding)
Press the switch (6.1) down and push it into
the left-hand position.
Choice of sanding pad
The tool can be fi tted with three sanding
pads of different hardnesses depending on
the surface to be sanded.
Hard: Coarse sanding on surfaces, sanding
at edges.
Soft: Universal use for coarse and fi ne
sanding for fl at and curved surfaces.
Super-soft: Fine sanding on formed parts,
curves, radii. Do not use on edges!
Installation
The FastFix system enables tool-free re-
placement of the sanding pad:
- Set the switch (7.1) to the right for the
- Press spindle stop (7.3), direction of move-
- Turn the fi tted sanding disk (7.2) from the
- Keep the spindle stop pressed and screw
8

Sanding motion

The change can only be made
The Rotex rotary motion is a combi-
nation of rotary and eccentric mo-
tions. This motion is recommended
for sanding with aggressive material
removal (coarse sanding) and polish-
ing.
This motion is recommended for
sanding with low material removal for
a scratch-free fi nish (fi ne sanding).
Choice and installation of sand-
ing pads
Rotex rotary motion,
ment fi rst to the side, then forwards,
spindle (right-handed thread),