Starting The Engine; Stop The Engine - Cub Cadet 17AICBYQ603 Instrucciones De Funcionamiento Originales

Operation
Using the ignition lock D
Note on the ignition lock
Depending on the model, the vehicle is
equipped with a standard ignition lock
with an ignition lock with OCR function
Ignition lock
To start the engine turn the ignition key to
the engine starts up). Then release the key.
The key stays in the position
To stop the engine turn the ignition key to the left
.
Ignition lock with OCR function
This is an ignition lock with OCR function (= user-
controlled mowing in reverse).
To start the engine turn the ignition key to
the engine starts up). Then release the key.
The key stays in the position
in a forward direction.
To activate OCR turn the key anti-clockwise
from normal position to reverse-mowing position
.
Press the switch [1].
The indicator lamp [2] is lit. You can now mow
both when moving forwards and when reversing.
To stop the engine turn the ignition key to the left
.
The OCR function is switched off automatically once
the key is turned to the normal position or the motor
is shut down (stop position or shutdown of the motor
through the safety lock system).
Note
Only use the OCR function if absolutely nec-
essary, otherwise use the normal position.

Starting the engine

Note on the choke
The choke is used for starting the device
with a cold engine. Some models have no
choke. The engine is automatically set to
the particular starting process. Follow the
separate instructions in the engine operating
manual.
Open the fuel tap (if present, see engine manual).
Sit down on the driver's seat.
Switch the cutter deck off.
Switch the parking brake on.
Set the throttle to .
If the engine is cold, pull the choke / set the
throttle to .
769-12352
Press the ignition key
tion lock):
or
.
(until
.
Reset the choke / throttle slowly until the engine is
running smoothly.

Stop the engine

(until
Set the throttle to the middle position.
for mowing Let the engine run for approx. 20 seconds.
Set the ignition key to
Remove the ignition key.
Switch the parking brake on.
Driving
A
B
C
E
Insert the ignition key into the ignition lock.
Turn the ignition key to
starts running.
Release the ignition key.
Set the ignition key to
Note
A start attempt should take a maximum of
5 seconds. Wait 10 seconds before trying
again.
.
WARNING!
Risk posed by abrupt starting, sudden
stopping and driving at an excessively high
speed.
Risk of accidents
Drive slowly and brake slowly.
Do not drive at excessive speed.
Be particularly careful when reversing.
Never change the direction of travel with-
When entering corners, always reduce
your speed and adjust the speed to the
turning radius (the tighter the corner, the
lower the speed).
Never adjust the steering column or the
driver's seat when in motion.
Never operate the device without the
cutter deck.
Attention!
Do not step on the forward or reverse pedal
while you are activating the brake pedal or the
parking brake is activated. This may damage the
gears.
Brake pedal
Forward pedal
Reverse pedal
Switch for parking brake/Speed control
EN
(depending on the igni-
until the engine
/ .
17