Preliminary Operations; Programme Activation - Jacuzzi sasha mi Manual De Uso Y Mantenimiento

Ocultar thumbs Ver también para sasha mi:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 110

preliminary operations

programme
activation
NB: activation is conditioned by the number of programmes performed (refer to the Chapter
"Scale removal cycle").
It is not possible to use programmes if the scale removal cycle is in progress.
■ If desired, you may enrich the steam bath using your own preferred essences or suitable
scented oil sticks: remove the dispenser from its housing, as indicated, and insert one oil
stick per dispenser; or use a few drops of your preferred essence. Re-close the dispenser,
pressing it down until it locks.
The oil sticks are available from Jacuzzi® Service Centres; we advise cutting the oil stick into
two pieces, and placing one in each dispenser.
■ Turn on the main switch: the system will enter into "awaiting instructions" mode and
the ON/OFF display key will light up white.
NOTE: when the appliance is powered, you must wait several minutes before using the
hammam (the thermometer symbol flashes when the ON/OFF button is pressed); this time
period allows the control system to initialise the electronic management system.
■ At the end of this phase (the thermometer symbol stops blinking), press the ON / OFF
button: the blue button light switches on and the programme keys - alarm and water
softener keys - simultaneously light up. Now the key panel is ready to receive input
commands.
NOTE:
- This mode lasts approximately one minute, after this time, if no key has been pressed, the
system reverts to "awaiting instructions" mode.
- The activation of any key is indicated by an acoustic signal.
- If an audio kit is installed (optional), the keys relative to the audio system , will also light up
on on the display.
■ Select one of the three programmes and activate it by pressing one of the indicated
keys (once pressed, the key will turn blue):
Warning: perform the following procedure if the Jacuzzi® remote control system has
been installed: press the key of the program selected, wait for it to go dim and press
again within 20 seconds.
41

Publicidad

Tabla de contenido
loading

Tabla de contenido