Troubleshooting - Jacuzzi sasha mi Manual De Uso Y Mantenimiento

Troubleshooting

In the event of malfunctioning and/or situations that necessitate assistance from a Jacuzzi®,
Service Centre, display keys will flash according to the detected problem, as described below.
Hammam
■ The number of programme sessions carried out exceeds 20.
This message acts as a reminder that only a few hammam, tepidarium and/or calidarium
sessions can be carried out before a scale removal cycle must be performed.
Hammam
■ The maximum number of programme sessions (30) have been carried out; the system
is locked.
You must perform a scale removal cycle (see the relevant chapter).
Hammam
■ One or more programmes have failed to activate
If you have just restored the power supply, wait a few minutes in order for the control system
to initialise the electronic management system; if you have attempted to activate one
programme immediately after another, you must wait until the steam generator can be
drained and rinsed.
- Try pressing the key of the selected programme, waiting for it to switch off and press again
within 20 seconds.
- The key panel lock may be engaged (see relative chapter).
- The key panel may be out of order. Contact Jacuzzi® Customer Service.
Hammam
■ Loading/emptying of water in the steam generator was not carried out.
Check that the water system is functioning correctly; try turning off and then turning on the
main switch, wait until draining and rinsing are complete and then try to re-start the function:
if the problem persists, contact a Jacuzzi® Service Centre.
Bio sauna/Roman sauna
■ There is a water shortage in the steamer.
Fill up the steamer, leaving 10 cm from its opening; if an automatic water filling device is
installed, check that the tap on the supply pipe is open and/or the water system is functioning
correctly.
Before filling the steamer tank, if this was in use, wait at least 5 minutes so
that the inner heating element can cool down.
Sauna and/or Hammam
■ The thermal fuse (sauna) and/or the thermostat (hammam) have tripped.
Wait a few moments until the signal disappears; if this fails to happen, try turning off and then
turning on the main switch and then try to re-start the function.
If the problem persists, contact a Jacuzzi® Service Centre. "
Sauna/Hammam
■ The temperature probe may be faulty.
Try turning off and then turning on the main switch and then try to re-start the function: if the
problem persists, contact a Jacuzzi® Service Centre.
58