Transport
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Maintenance and care
Danger
Risk of injury by inadvertent startup of ap-
pliance and electrical shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.
Set the appliance switch to "0".
Shut off water supply.
Turn on pump shortly (appr. 5 seconds)
with device switch.
Pull main plug out of socket with dry
hands only.
Remove water connection.
Activate hand spray gun until device is
pressure less.
Secure hand spray gun, Figure 5 (A).
Allow device to cool down.
Your Kärcher vender will inform you
about the performance of a periodic
safety inspection resp. signing of a
maintenance contract.
Maintenance intervals
Weekly
Clean the sieve in the water connection.
Check oil level.
Caution
In case of lacteous oil inform Kärcher cus-
tomer service immediately
Monthly
Clean sieve in the water shortage safe
guard.
Clean filter at the detergent suck hose.
After 500 operating hours, at least annu-
ally.
Oil change.
At least every 5 years, recurring
Perform the pressure test as per manu-
facturer's instructions.
Maintenance Works
Clean the sieve in the water connection
Take out sieve.
Clean sieve in water and reinstall.
Clean sieve in the water shortage safe
guard
Figure 7
Loosen covering nut and take off hose.
Figure 8
Take out sieve.
Note: If necessary turn in screw M8 appr. 5
mm inwards and therewith pull out sieve.
Clean sieve in water.
Push sieve inwards.
Put on hose.
Tighten covering nut firmly.
Clean filter at the detergent suck hose
Figure 9
Take out detergent suck hose.
Clean filter in water and reinstall.
Oil change.
Figure 10
Ready a catch bin for appr. 1 Liter oil.
Kärcher Hint: Use a sliced RM 110 bottle as
a catch gutter.
ready catch gutter.
loosen release screw.
Release oil over the catch gutter into
the catch bin.
Dispose of old oil ecologically or turn in at
a gathering point.
Tighten release screw.
Fill oil slowly up to the MAX marking.
Note: Air pockets must be able to leak out.
For oil type refer to technical specifica-
tions.
– 9
EN
33