Acoustic Signal - Intra-Lock INTRA-SPIN Manual

19.2

Acoustic signal

The acoustic signal sounds:
• after a malfunction occurs in a 2-second interval.
• after ending the centrifugation run and the rotor is at a standstill in a 30-second interval.
The acoustic signal is ended by pressing any key.
If the rotor is at a standstill, the acoustic signal can be set as follows:
The procedure can be aborted at any time by pressing the
• Press and hold the button for eight
SELECT
seconds.
↓
• Press the key until the following is
SELECT
displayed.
↓
• Press the key.
START
PULSE
End beep : Acoustic signal after ending
the centrifugation run.
off : Signal deactivated.
on : Signal activated.
↓
t
• With the keys, set off or on.
↓
• Press the key.
SELECT
Error beep : Acoustic signal after a
malfunction occurs.
off : Signal deactivated.
on : Signal activated.
↓
t • With the keys, set off or on.
↓
• Press the key.
SELECT
Beep volume : Volume of the acoustic
signal.
min : soft
mid : medium
max : loud
↓
t
• With the keys, set min, mid, or max.
↓
Continued on next page
STOP
OPEN
key. In this case, the settings are not stored.
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
EN
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
23/446