Bmi Working Mode - Soehnle 6958 Instrucciones De Manejo

6. Operation

6.4 BMI working mode

To make BMI working Mode be available, CONFIG-FUNC-BMI menu item should be set to YES and
f
factory setting should be also enable this function.
To enter BMI working mode:
f
When CONFIG-FUNC-ACCUMU=Yes: If In normal weighing mode, percent weighing mode, or counting
f
mode, press [PRINT/FUNC] key long, then WEIGH or COUNT or PERCEN will be shown, use [ACC/TOTAL]
or [PRINT/FUNC] key to select BMI, then press [TARE/PRESET] to confirm go to BMI mode.
When CONFIG-FUNC-ACCUMU=NO: press [ACC/TOTAL] (BMI) key, to go to BMI mode.
f
After scale went to this mode, "CM.xxx" (means: last input height is xxx cm) will be displayed.
f
Wait for input height:
(1) To change height unit to cm or inch by pressing [UNIT/DATA] key
(2) To change height number by using [PRINT/FUNC], [ACC/TOTAL] (BMI) keys
(3) Press and hold [PRINT/FUNC] or [ACC/TOTAL] (BMI) key will increase or decrease number
(4) Press [TARE/PRESET] key to confirm the input.
Press [ZERO/ON/OFF] key to exit input data mode and return to BMI working mode.
The range of height is 50-250cm and default is 170cm.
In this mode, when BMI number is shown (BMI symbol is also on), or weight number is shown (BMI
f
and kg or lb announciators are on), Press [ACC/TOTAL] key to select weight or BMI number to be
displayed, when weight is displayed, the weight unit can be selected by pressing [UNIT/DATA] key, and
BMI and weight unit will be displayed at same time.
In this mode, when current net weight is less than NLD.RNG, the indicator will go to display weight
f
number if CONFIG-FUNC-ACCUMU=No; or the indicator will back to original working mode if
CONFIG-FUNC-ACCUMU= Yes.
39