Explanation Of Symbols & Troubleshooting; Explanation Of Symbols - Soehnle 6958 Instrucciones De Manejo

7. Explanation of symbols & Troubleshooting

7.1 Explanation of symbols

Zero is over the setting range
----
0
Zero point is below the setting range
0
____
Signal to ADC is over max. range
----
Ad
Signal to ADC is below min. range
Ad
____
Weight is over upper limitation, or display data is over limitation
----
Weight is below lower limitation
____
CONFIG or CAL parameters are not correctly set
EEP.E1
USER parameter is not correctly set
EEP.E2
Battery voltage is lower than setting.
Lo.bAt
Next displaying content is Capacity
CAP - - -
Parameters about Capacity is not correct
CAP.ER
Calibration on point(x)
CAL.Px
Calibration Seal Switch is on OFF position
CAL.OFF
Calibration Seal Switch is on ON position
CAL.ON
Calibration error, maybe input data or loaded weight is incorrect, unstable, un-linear
CAL.Er
Calibration is end
CAL.En d
Terminal is turned off
oFF
Unstable time is lager than setting of USER-HOLD-STB.TIM
STB.ER
Accumulation times is xxx
AcC.x x x
Preset TARE weight
PR.TARE
Go to COMPARE data mode
COMP
Input HIGH limitation data of comparison
HIGH
Input LOW limitation data of Comparison
LOW
Sample load weight of low point.
SPL.Lo
Sample load weight of high point.
SPL.HI
Sample goods weight to calculate piece weight
SPL.PWT
Input pieces number of weighted goods
INP.PCS
Unit kg is selected
UNIT.KG
Unit lb is selected
UNIT.LB
Piece weight error, too small (<0.5d)
PWT.ER
Sample goods weight to calculate
SPL.PCT
Input percentage of weighted goods
INP.PCT
Unit-Percentage -Weight is too small (<0.5d).
PCT.ER
Internal calculation overflows
CACU.ER
43