Soehnle 6958 Instrucciones De Manejo página 35

6. Operation
Change weight unit:
f
Press [UNIT/DATA] key short, to select the units kg, lb, lb:oz, g or oz.
Note: Under some conditions, the units g and lb:oz are not available
Check weight in weighing mode:
f
(1) To make weight compare function be available, CONFIG-FUNC-COMPAR item should set to YES,
and high and low limitation of weight should be set correctly according to following steps:
(2) In weighing mode, press [UNIT/DATA] key for more than 3 seconds to input compare data of high
and low. When UNIT.KG is shown, use [PRINT/FUNC] or [ACC/TOTAL] key to select the unit of
weight. Use [TARE/PRESET] key to confirm and go to next. Press [ZERO/ON/OFF] key to exit and
go back to weighing mode.
(3) After HIGH being shown, 000000 will be displayed, use the arrow keys to input high weight
number and press [TARE/PRESET] key to confirm. The symbol „Hi" will be shown in this step.
Press [ZERO/ON/OFF] key to exit and go back to weighing mode.
(4) After Low being shown, 000000 will be displayed, use keys to input low weight number and press
[TARE/PRESET] key to confirm. The symbol „Lo" will be shown in this step. Press [ZERO/ON/OFF]
key to exit and go back to weighing mode.
Note: If High number is 0 or is equal or less than low number, the comparison will be disabled,
and the input data has no limitation.
(5) After a reasonable limitation is set and compare is be active, one of the symbols HI, OK, LO will be
lighted, and the beeper will sound according to its setting in USER-BEEP.
Accumulation:
f
Press [ACC/TOTAL] key to add displayed number to accumulation memories, and accumulation times
will also add up 1. And then to display accumulation result.
Data output:
f
When reading is stable, press the [PRINT/FUNC] key.
Change working mode:
f
Press [PRINT/FUNC] keylong, then use the arrow keys to choose and confirm to enter into weighing
mode, counting mode, percentage working mode or BMI working mode.
Enter to or exit from HOLD mode:
f
Press the [HOLD/SETUP] key.
Enter Setup mode:
f
(1) If you need to set configuration parameters, set user parameters, calibrate the scale, set current
date or time, test some hardware. It is necessary to press the [HOLD/SETUP] key long, to enter
setup mode
(2) After entering Setup mode, the main menu item CONFIG will be shown first.
(3) In Setup mode, use the arrow keys to select the wanted submenu and the wanted menu item,
select wanted choice, set wanted number, confirm and save data or exit this mode.
.
35