Initial Setup - BD PureWick PW100 Guía Del Usuario Y Garantía

Initial Setup

1. Inspect the package for damage. If any damage is noticed, contact Customer
Support at 1-888-201-1586 immediately.
2. Carefully remove all contents from the package, including the packing material
and inspect prior to use. If any damage is noticed, contact Customer Support at
1-888-201-1586 immediately.
3. Place the PureWick™ Urine Collection System (A) next to the bed or chair where it will
be used. It must be close enough for the collector tubing with elbow connector (G)
to easily reach the user and should be placed on a stable, even surface. For optimal
results, position the PureWick™ Urine Collection System either on the floor or as close
to the floor as your facility's protocol will allow.
Note: The PureWick™ Urine Collection System should be stationary while in use.
Device is not designed to be used while in transport.
CAUTION: Avoid creating a tripping hazard with the collector tubing or power cord.
4. Plug the PureWick™ Urine Collection System power cord into device outlet (B) and
into an A/C power outlet.
Note: The device should be positioned for easy access to the A/C inlet and power cord.
Note: Make sure the power switch is turned off before connecting the power cord.
• Battery Power Operation (PW200 Only)
The built-in battery recharges any time the device is plugged into an outlet.
To fully charge the battery, the system must be plugged in for 12 hours. The
battery will supply 8 hours of backup power before requiring recharging. The
PureWick™ Urine Collection System remains fully functional while the device
is recharging.
Battery Life Status - Green LED Light
No Light
Solid
Slow Blink
Fast Blink
Note: If it is too cold or hot, charging time may be longer or battery may not fully charge.
5. Place the collection canister (C) in the PureWick™ Urine Collection System base and
press down firmly on the lid making sure the lid is sealed. Optional (prior to sealing
canister lid): While operating the PureWick™ Urine Collection System, ammonia odor
for up to 1800 mL of urine can be eliminated by adding 2 teaspoons (10 grams)
of vitamin C (ascorbic acid) powder into the collection canister before use. At least
99.93% of pure vitamin C (ascorbic acid) is recommended. If using the privacy cover
(J), slip privacy cover onto canister (similar to a coffee cup sleeve) prior to placing
canister into the base. Attach the pump tubing (D) to the PureWick™ Urine Collection
System connector port (F) and the connector port (E) on the collection canister lid.
Device is powered off
Device is on and fully charged
Device is charging
Operating on battery; battery less than 20%
3