Guidance and Manufacturer's Declarations
Table 1: Electromagnetic emissions
This equipment is intended for use in the electromagnetic environment specified below.
The user of the equipment should assure that it is used in such an environment
Emissions Test
Radiated emissions
EN 55011
Conducted emissions
CISPR 11 / EN 55011
AC Power-line harmonics
IEC 61000-3-2
AC Power-line Flicker
IEC 61000-3-3
Table 2: Electromagnetic immunity
This equipment is intended for use in the electromagnetic environment specified below.
The user of the equipment should assure that it is used in such an environment.
Immunity Test
Electrostatic discharge
IEC 61000-4-2
Radiated RF Immunity
IEC 61000-4-3
Electrical Fast
Transient/Burst
IEC 61000-4-4
Surge Immunity
IEC 61000-4-5
Conducted RF
immunity
IEC 61000-4-6
Power Frequency
H-field
IEC 61000-4-8
Voltage Dips,
Interrupts
IEC 61000-4-11
IEC 60601 test level
+ 8 kV Contact, HCP & VCP
+2 kV, +4 kV, +8 kV, + 15 kV Air
80 MHz - 2.7 GHz, 10 V/m,
80% 1 kHz AM
+ 2 kV (100 kHz rep rate)
AC mains
+ 1 kV (100 kHz rep rate) I/O > 3m
+0.5 kV & + 1 kV line-line,
AC mains
+0.5 kV, + 1 kV, + 2 kV lineground,
AC mains
150 kHz to 80 MHz, 3 Vrms, 80%
1 kHz AM, power and I/O
6 Vrms (+modulation) for
ISM frequencies
50 and 60 Hz, 30 A/m,
x-, y-, and z- axes
100% reduction for 0.5 cycles
100% reduction for 1.0 cycle
30% reduction for 25/30 cycles
100% reduction for 250/300 cycles
Compliance
Complies (Group B, Group 1)
Complies
Complies
Complies
Compliance level
+ 8 kV Contact, HCP & VCP
+2 kV, +4 kV, +8 kV, + 15 kV Air
80 MHz - 2.7 GHz, 10 V/m,
80% 1 kHz AM
+ 2 kV (100 kHz rep rate)
AC mains
+ 1 kV (100 kHz rep rate) I/O > 3m
+0.5 kV & + 1 kV line-line,
AC mains
+0.5 kV, + 1 kV, + 2 kV lineground,
AC mains
150 kHz to 80 MHz, 3 Vrms, 80%
1 kHz AM, power and I/O
6 Vrms (+modulation) for
ISM frequencies
50 and 60 Hz, 30 A/m,
x-, y-, and z- axes
100% reduction for 0.5 cycles
100% reduction for 1.0 cycle
30% reduction for 25/30 cycles
100% reduction for 250/300 cycles
14