Next Level Racing Elite Serie Manual De Instrucciones página 10

support@nextlevelracing.com
FRONT/ SIDE MOUNT CONFIGURATION
02b
Align the holes on the Wheel Deck Mounting Bracket with the matching holes on the Wheel Deck of
your cockpit. Secure using M6 Bolts, Washers and Wing Nuts.
03
Loosen the Wing Nuts and adjust the Wheel Deck Mounting Bracket to your desired angle, tighten the
Bolts to lock in place.
PARTS:
• • 2x M6 16mm Head Bolts
• • 2x M6 Washers
• • 2x M6 Wing Nuts
PARTS:
( )
ANGLE ADJUSTMENT
• • NIL
18
OPTIONAL 3M TAPE MOUNT
NOTES:
- Ensure the Wheel Deck surface is clean and free of any contaminants and residue.
- Recommended drying time of 72 hours for 3M Tape before attaching any electronics.
- Please note you won't be able to adjust the angle/ position of the Mounting Bracket once it adheres to
the surface.
04
Peel off the 3M protective layer underneath the Wheel Deck Mounting Bracket and install it at the
desired location and angle.
OPTIONAL CONFIGURATION
SETUP
( )
Through Holes
01
Install 1x NLR Cable Management Clip into the bottom channel of the Aluminium Extrusion.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • NIL
( )
Peel 3M Tape
PARTS:
• • 1x Aluminium Extrusions
• • 1x Cable Management Clip
19