Next Level Racing Elite Serie Manual De Instrucciones página 13

support@nextlevelracing.com
NOTE: Install T-Nuts suited for your
cockpit extrusion profile.
10 Install 2 x T-Nuts into the outside channels of the uprights of your Elite Series
Cockpit.
)
A
)
B
11
A) Align the holes on the Mounting Bracket with the T-Nuts previously installed in STEP 10.
B) Bolt through and secure using M8 Bolts and Washers.
24
PARTS:
• • 2 x T-Nuts
FGT ELITE COCKPIT
GTELITE COCKPIT
12
PARTS:
• • 2x M8 16mm Bolts
• • 2x M8 Washers
13
Loosen the Wing Nuts in the joints of the arm to adjust the angle of each section to your
desired position. Tighten the Wing Nuts after achieving the final desired configuration.
Loosen the Wing Nut in the Tablet Mount Connector Bracket. Adjust to the desired angle and tighten
the Wing Nut to lock in place.
25
Video Instruction: bit.ly/nlrbuild
PARTS:
• • NIL
PARTS:
• • NIL