Next Level Racing Elite Serie Manual De Instrucciones página 12

support@nextlevelracing.com
( )
Tabs
)
A B
A) Align the slots on the Tablet Top Clamp (the tabs should be at the top, as shown in the picture)
06
with the pressed studs on the Tablet Bottom Clamp.
B) Secure using M8 Wing Nuts.
BUTTON BOX SETUP
(SMART PHONE COMPATIBLE)
) )
A B
A) Align the slots on the Button Box Top Clamp with the pressed studs on the Button Box
07
Bottom Clamp.
B) Secure using M8 Wing Nuts.
PARTS:
• • 1x Tablet Top Clamp
)
• • 1x Tablet Bottom Clamp
• • 2x M8 Wing Nuts
PARTS:
• • 1x Button Box Top Clamp
• • 1x Button Box Bottom Clamp
• • 2x M8 Wing Nuts
22
) )
A B
A) Align the holes on the pre-assembled Tablet Holder with the pressed studs on the pre-assembled
08
Button Box Holder.
B) Secure using M8 Wing Nuts.
Note: Replace the Wing Nut with a
Flange Nut for a fixed setup.
) )
A B
A) Align the holes on the Tablet Mount Connector Bracket with the holes on the back of the Tablet Holder.
09
B) Align a 43mm Barrel Spacer in between the Tablet Mount Connector Bracket. Bolt through and secure using
M8 Bolt, Washer and Wing Nut.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 2x M8 Wing Nuts
PARTS:
• • 1x M8 60mm Bolt
• • 1x M8 Washer
• • 1x M8 Wings Nut
• • 1x 43mm Barrel Spacer
23