Next Level Racing Elite Serie Manual De Instrucciones página 6

support@nextlevelracing.com support@nextlevelracing.com
09
Align a 43mm Barrel Spacer in between the two brackets from Step 08. Bolt through using M8 Bolt,
Washer and Wing Nut.
10
Align the holes on the Tablet Mount Connector Bracket with the holes on the External Swivel
Bracket (ESB).
PARTS:
• • 1x M8 70mm Bolt
• • 1x M8 Washer
• • 1x M8 Wing Nut
• • 1x 43mm Barrel Spacer
NOTE: Replace the Wing Nut with a
Flange Nut for a fixed setup.
PARTS:
• • 1x Tablet Mount Connector
Bracket
10
NOTE: Replace the Wing Nut with a
Flange Nut for a fixed setup.
11
Align a 36mm Barrel Spacer in between the two brackets from Step 10. Bolt through and secure with
an M8 Bolt, Washer and Wing Nut.
( )
Tabs
) )
A B
A) Align the slots on the Tablet Top Clamp with the pressed studs on the Tablet Bottom Clamp. (The tab should be at the top
12
facing up, as shown in the picture)
B) Secure using M8 Wing Nuts.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • 1x M8 60mm Bolt
• • 1x M8 Washer
• • 1x M8 Wing Nut
• • 1x 36mm Barrel Spacer
PARTS:
• • 1x Tablet Top Clamp
• • 1x Tablet Bottom Clamp
• • 2x M8 Wing Nuts
11