Operation - Kärcher Puzzi 8/1 C Manual Del Usuario

Defoaming agent
Note: When cleaning previously sham-
pooed carpets, foam is generated in the
wastewater container. This formation of
foam can be prevented by adding a de-
foaming agent.
Put defoaming agent (optional accesso-
ry) into the wastewater container.

Operation

Turning on the Appliance
Plug in the main plug.
Press the suction switch to turn on the
suction turbine.
Press the spray switch to switch on the
spray pump.
Cleaning
Caution
Risk of damage. Check the object to be
cleaned prior to using the appliance in an
inconspicuous place for colour fastness
and water resistance.
Operate the lever on the manifold in or-
der to spray the cleaning solution.
Run across the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
When changing nozzles, the hand noz-
zle can be put into the accessories
holder.
Turn off the appliance
Switch off the spray and suction switch-
es.
Pull out the mains plug.
Empty wastewater container
If the dirt water reservoir is full, switch
off the suction and spray switches.
Remove the lid.
Remove the wastewater container from
the appliance and drain it.
Empty the fresh water reservoir
Turn off the appliance.
Shortly activate the lever on bender to
decrease the pressure.
Separate bender from the spray/suction
hose.
Insert the suction hose into the fresh
water reservoir.
Press the suction switch to turn on the
suction turbine.
Empty the fresh water reservoir and
switch the appliance off.
Remove the lid.
Remove the wastewater container from
the appliance and drain it.
Flush appliance
Connect the elbow (with hand nozzle)
to the suction hose.
Connect the coupling of the spray hose
with the manifold and snap in place.
Fill approx. 2 litres of fresh water into
the fresh water reservoir.
Do not add any detergents.
Press the spray switch to switch on the
spray pump.
Hold hand nozzle over a drain.
Activate lever on bender and flush the
appliance for appr. 1 to 2 minutes.
Turn off the appliance.
After each operation
Flush appliance.
Empty the wastewater container and
clean it under running water.
Empty the fresh water reservoir.
Clean the outside of the appliance with
a damp cloth.
Remove all water from the appliance
prior to longer periods of non-use to
avoid offensive odours.
Allow appliance to dry thoroughly: Re-
move or move lid sideways.
– 3