EDM Koma Pro 08338 Manual De Instrucciones página 52

English
maintain proper foot support and run the machine only
when standing on a fixed surface, safe and stable. Or
unstable sliding surfaces may cause loss of balance or
control of the machine.
Keep all parts of body away from the cutting elements
when the machine is running. Before start up, make sure
that the cutting element is not in contact with any object.
One small lapse in attention can cause your clothes or any
body part to be caught by the cutting device.
Always use the brushcutter attached to the harness and
grip machine with your right hand on the rear handle and
your left hand on the front handle. Hold this machine with
hands reversed increases the risk of bodily injury and
should not be done.
Be extremely careful when cutting shrubs and young
trees. Thin materials can be projected towards the end
user or could make you lose your equilibrium.
If you are a novice user, we recommend you have a
minimum practice on a flat surface
If the machine vibrates abnormally stop the engine,
inspect the machine looking for the possible cause and
repair. If you don't find the reason take your machine at
your service.
Do not touch the exhaust of the machine with the engine
running or just after it has been stopped. The exhaust of
this machine reaches high temperatures during operation
of the engine and kept some minutes after the stop
thereof.
Do not leave the machine running unattended. If you must
leave the machine unattended shut off the engine, wait
until the cutting device stops and unplug the spark plug
wire.
When transporting the machine, make sure it is hooked to
the harness and with your hands on the handles, with the
engine stopped, with the blade protector and at a distance
from your body parts.When transporting or storing the
machine, always cover the blade. An appropriate use
of the machine will greatly reduce the risk of accidental
contact with the cutting elements.
Do not attempt to remove cut material from the work area
or the cutting device when it is in motion. Be sure the
machine is off when you perform cleaning debris.
Do not handle the machine by the cutting device. The
cutting device has sharp edges that can hurt yourself.
Store the machine well away from children.
Never use the machine if the protections are defective or
without all security devices in proper working order. Do
not modify the machine controls or the engine speed.
2.2.1.WORKING CLOTHES AND SECURITY EQUIPMENT
Dress adequately. Do not wear loose clothing or jewels.
Maintain your hair, clothes and gloves well away from all
moving parts.
When using this tool wear the next safety equipment:
- Security glases or protective mask.
- Ear protection.
- Working gloves.
- Non slippery boots.
- Long trousers.
The use of additional working and security
equipment will reduce the risk of personal injury.
The noise of the machine is uncomfortable.
Always use ear protection. If you use this machine
very often, visit your doctor regularly to check up
on your hearing capacity.
Attention! As you are working with ear protectors, you
52/100