Mounting The Cutting Disc; Filling The Fuel Tank - EDM Koma Pro 08338 Manual De Instrucciones

6.2.5. MOUNTING THE CUTTING DISC

1
3
3
7
5
6.2.6. HARNESS INSTALLATION
2
1
4
4
6.3. FUEL
IMPORTANT: The fuel used is highly
inflammable. If the fuel or the machine catch
fire, fight the flames with a dry dust fire
extinguisher.
Do not smoke while preparing or refueling. Do
not approach any flame or hot element to the
fuel.
Use unleaded fuel of 95° and synthetic oil
for 2 stroke engines.
Motor Fuel: Mixture (Gasoline 40: Oil 1)
2.5%.
Mix gasoline and oil in a bottle homologated for this use.
If you will mix more combustible just prepare the amount
you will use the short term. Do not use fuel that has been
stored over two months. The fuel stored for long periods
lose its characteristics making it harder to start the engine
and giving poorer performance.

FILLING THE FUEL TANK

1. Choose an open are ato perform this situation
2. Stay away from the area where you have made the
preparation of the mixture.
3. Remove the combustible tank cap and fill with fuel.
4. Close tighly the fuel cap and remove all traces of
fuel that have been spilled with a rag.
WARNINGS:
- Always switch off the engine before refueling.
- Do not start the machine in a closed area. The
exhaust fumes and the vapours of the petrol all
contain carbon monoxide and other dangerous
chemical substances. In case of gas concentration
due to insufficient ventilation, eliminate from the
work area everything that
61/100
English
impedes the correct flow